Product Description
BSI FINISH-CURE 20 Minute Epoxy 4 1/2 oz. (BSI209)
This is a four and a half ounce package of Bob Smith Industries FINISH-CURE™ 20 Minute Epoxy. FINISH-CURE™ 20 minute epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE™ can be sanded the easiest of all the BSI epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing. For best results, FINISH-CURE™ should be heated to a temperature above 85*F or when applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE™. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a light weight finish. If room temperature is below 70*F use a heat gun on the surface several times for the next 2 hours. When dry, lightly sand, then fill surface with a low weight spackling compound, scrapping off excess with a playing card. Sand to a smooth finish ready for primer. For heavy weight fiberglass, apply the epoxy before and after laying down the cloth. FINISH-CURE™ is best mixed in a disposable cup.
Features:
- Works best on Fiberglass, White Foam, Laminating, Water-Resistant
- Works well on Balsa Wood, Hard Wood
- For applying to lighter weight fiberglass, lay the cloth on the surface and brush FINISH-CURE™ through the cloth.
- For heavier cloth, apply the epoxy on the surface first, then brush FINISH-CURE™ through the cloth.
- When using FINISH-CURE™ for the sheeting of foam wings, make sure to apply FINISH-CURE™ to the wood and not the foam.
- Acetone and isopropyl alcohol work as the best solvents for cleaning uncured epoxy from surfaces
Includes:
- (1) 4.5 oz Hardener Epoxy
- (1) 4.5 oz Resin Epoxy
